Cruise Control Main Switch: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY
1. Install the switch and steering wheel boss cover lower.
2. Install the 3 screws.
  
  Fig 1: Locating Switch And Steering Wheel Boss Cover Lower Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 3 screws.
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
INSTALL STEERING PAD ASSEMBLY (See DISPOSAL )

Fig 2: Locating Steering Wheel Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD SWITCH MODULATOR
1. Install the modulator and then connect the connector.
2. Install the 2 screws.
  
  Fig 3: Locating Steering Pad Switch Modulator Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SWITCH AND VOLUME CASE
1. Attach the 3 claws to install the case.
INSTALL NO. 2 STEERING WHEEL COVER LOWER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
  
  Fig 4: Applying Protective Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002