Navigation Antenna: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL NAVIGATION ANTENNA ASSEMBLY 
   1. Install the antenna with the 2 screws.
      Fig 1: Locating Navigation Antenna Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the 2 clamps.
2. INSTALL INSTRUMENT PANEL REINFORCEMENT (See  INSTALLATION  ) 
3. INSTALL NO. 2 HEATER TO REGISTER DUCT (See  INSTALLATION  ) 
4. INSTALL NO. 3 HEATER TO REGISTER DUCT (See  INSTALLATION  ) 
5. INSTALL NO. 1 HEATER TO REGISTER DUCT (See  INSTALLATION  ) 
6. INSTALL FRONT DEFROSTER NOZZLE (See  INSTALLATION  ) 
7. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT (See  INSTALLATION  ) 
8. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT (See  INSTALLATION  ) 
9. INSTALL NO. 1 INSTRUMENT PANEL PIN (See  INSTALLATION  ) 
10. INSTALL STEERING COLUMN ASSEMBLY (See  INSTALLATION  ) 
11. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 
    1. Install the instrument panel safety pad (see INSTALLATION ).
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.