Park / Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the automatic transmission.
2. Temporarily install the bolt.
  
  Fig 1: Locating Park/Neutral Position Switch Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer with the nut.
  Torque: 6.9 N*m (70 kgf*cm, 62 in.*lbf)
  
  Fig 2: Locating Lock Washer With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the control shaft lever.
  
  Fig 3: Locating Control Shaft Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
6. Remove the transmission control shaft lever.
  
  Fig 4: Turning Control Shaft Lever N Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the neutral basic line with the switch groove, and tighten the adjusting bolt.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  Fig 5: Aligning Neutral Basic Line With Switch Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Using a screwdriver, bend the tabs of the lock washer.
  HINT:
  
  Bend at least 2 washer tabs.
  
  Fig 6: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Install the transmission control shaft lever RH with the nut.
  Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf)
  
  Fig 7: Locating Control Shaft Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Connect the park/neutral position switch connector.
CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See INSTALLATION )
INSTALL CENTER EXHAUST PIPE ASSEMBLY
1. Install the center exhaust pipe (see INSTALLATION ).
  
  Fig 8: Identifying Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY
1. Install the front exhaust pipe (see INSTALLATION ).
INSTALL FRONT FLOOR CENTER BRACE
1. Install the floor brace with the 4 bolts.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
CONNECT HEATED OXYGEN SENSOR (for Sensor 2)
1. Connect the sensor (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See REMOVAL )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See ON-VEHICLE INSPECTION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.