Removal

2GR-FE ENGINE CONTROL SYSTEM: ACCELERATION SENSOR:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE ENGINE UNDER COVER LH
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE COOL AIR INTAKE DUCT SEAL Removal
5. REMOVE ENGINE ROOM SIDE COVER LH Removal
6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
7. REMOVE AIR CLEANER INLET ASSEMBLY Removal
8. REMOVE NO. 1 AIR CLEANER INLET Removal
9. REMOVE ACCELERATION SENSOR





(a) Disconnect the acceleration sensor connector and clamp.





(b) Remove the 2 nuts and acceleration sensor.