Jam Protection Function Does Not Operate: Procedure

1. Initialize the power window regulator motor assembly (applicable location) . Refer to INITIALIZATION .
2. Check if the power window AUTO UP/DOWN function operates normally.

   OK

   AUTO UP/DOWN function operates normally.

NG → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

OK: Go to next step 

1. Check if the jam protection function operates normally for the applicable power window.

   HINT: 

   The jam protection function will not operate within 4 mm (0.157 in) of the fully closed position.

   OK

   Jam protection function operates normally.

   Result

   Result	Proceed to
   OK	A
   NG (Front LH side power window)	B
   NG (Front RH side power window)	C
   NG (Rear LH side power window)	D
   NG (Rear RH side power window)	E

E → See step   6 

D → See step   5 

C → See step   4 

B → See step   3 

A → END