Radio Receiver: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 3 BOX PANEL (See REMOVAL )
REMOVE REAR CONSOLE PANEL UPPER (See REMOVAL )
REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
1. Remove the 2 bolts.
  
  Fig 1: Locating Radio Receiver Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull the radio receiver to detach the 4 clips on the backside of the radio receiver.
3. Disconnect the connectors and remove the radio receiver.
  
  Fig 2: Pulling Radio Receiver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
1. Detach the 5 clips and remove the panel.
  
  Fig 3: Removing Instrument Cluster Finish Panel Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 RADIO BRACKET
1. Remove the 4 bolts and bracket.
  
  Fig 4: Locating Bolts And No. 2 Radio Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 RADIO BRACKET
1. Remove the 4 bolts and bracket.
Fig 5: Locating Bolts And No. 1 Radio Bracket
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002