Typical Malfunction Thresholds
Functional check:
TYPICAL MALFUNCTION THRESHOLDS
| Either of the following conditions is met: | condition 1 or 2 |
| 1. Frequency that following conditions (a) and (b) are met: | 5 times or more |
| (a) Either of the following conditions is met | condition A or B |
| A. Engine RPM - target engine RPM | Below -100 RPM, or 150 RPM or more (A/C off and NSW off) |
| B. Engine RPM - target engine RPM | Below -100 RPM, or 200 RPM or more (A/C on or NSW on) |
| (c) Vehicle condition | Stop after vehicle was driven by 6.25 mph (10 km/h) or more |
| 2. Frequency that following conditions (a) and (b) are met: | Once |
| (a) Either of the following conditions is met | condition A or B |
| A. Engine RPM - target engine RPM | Below -100 RPM, or 150 RPM or more (A/C off and NSW off) |
| B. Engine RPM - target engine RPM | Below -100 RPM, or 200 RPM or more (A/C on or NSW on) |
| (c) ISC flow rate learning value | 1.69 L/sec. or less or 10.08 L/sec. or more |