LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 460 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System Testing; Component Inspection, Removal & Installation >> Accelerator Pedal >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester ON.
    4. Enter the following menus: Powertrain/Engine/Data List/ETCS/Accelerator Position No. 1 and accelerator Position No. 2.
    5. Read the value displayed on the tester.

      ACCEL POS #1 (Accelerator Position No. 1) standard voltage 

      STANDARD VOLTAGE SPECIFICATION

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      ACCEL POS #2 (Accelerator Position No. 2) standard voltage 

      STANDARD VOLTAGE SPECIFICATION

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness or ECM.

scientia non olet · About LEMON Manuals