On-Vehicle Inspection
- INSPECT FUNCTION OF CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and turn the tester on.
- Start the engine and warm it up.
- Engine is idling.
- Enter the following menus: Powertrain/Engine/Active Test/Control the VVT-iE Linear (Bank 1) or Control the VVT-iE Linear (Bank 2)/All Data/VVT Aim Angle (#1) and VVT Change Angle (#1) or VVT Aim Angle (#2) and VVT Change Angle (#2).
- Perform the Active Test operation with the engine speed at 1500 RPM.
OK
ACTIVE TEST REFERENCEActive Test Movement Order Difference between "VVT Aim Angle" and "VVT Change Angle" 0 deg → 10 deg → 20 deg → 40 deg → 10 deg → 0 deg → 10 deg → END Within 4 DegFR HINT:
If not within the standard, inspect the camshaft timing control with EDU motor assembly and camshaft timing gear assembly (See INSPECTION ).