On-Vehicle Inspection

1. Move the shift lever to P.
2. Turn the engine switch off.
3. Check that the shift lever cannot be moved from P.
4. Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.

1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position.

If the operation cannot be performed as specified, check the shift lever assembly.

1. Measure the voltage according to the value(s) in the table below.

   HINT:

   Do not disconnect the shift lock control ECU connector.

   Standard Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   12 (IG) - 3 (E)	Engine switch on (IG)	11 to 14 V
   12 (IG) - 3 (E)	Engine switch off	Below 1 V
   6 (STP) - 3 (E)	Brake pedal depressed	11 to 14 V
   6 (STP) - 3 (E)	Brake pedal released	Below 1 V

   Fig 1: Identifying Shift Lock Control ECU Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   HINT:

   Do not disconnect the shift lock control ECU connector.

   Standard Resistance 

   RESISTANCE REFERENCE
   
   

   Tester Connection	Condition	Specified Condition
   3 (E) - Body ground	Always	Below 1 Ω

   If the result is not as specified, replace the transmission floor shift assembly.

   Fig 2: Identifying Shift Lock Control ECU Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002