LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 460L AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication >> Can Communication System >> DTC U0327 Software Incompatibility with Vehicle Security Control Module >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
      NOTE:
      • After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  2. CHECK FOR OPEN IN CAN BUS WIRE (CERTIFICATION ECU BRANCH WIRE) 
    1. Disconnect the L15 certification ECU connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Switch Condition Specified Condition
      L15-27 (CANP) - L15-28 (CANN) Engine switch off 54 to 69 Ω
      Fig 1: Identifying L15 Certification ECU Connector Terminals
      G06198538Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      NG: REPAIR OR REPLACE CERTIFICATION ECU BRANCH WIRE OR CONNECTOR (CANP, CANN) 

      OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND) 
    1. Connect the cable to the negative (-) battery terminal.
      NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    2. Disconnect the L15 certification ECU connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      L15-17 (E) - Body ground Always Below 1 Ω
    4. Measure the voltage according to the value(s) in the table below.
      Fig 2: Identifying L15 Certification ECU Connector Terminals
      G06198539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard voltage 

      SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      L15-1 (+B1) - Body ground Always 11 to 14 V
      L15-20 (CUTB) - Body ground Always 11 to 14 V
      L15-18 (IG) - Body ground Engine switch on (IG) 11 to 14 V

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: REPLACE CERTIFICATION ECU 

scientia non olet · About LEMON Manuals