LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 460L AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - System Testing; Component Inspection, Removal & Installation >> HEATED OXYGEN SENSOR (for 2WD) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

HEATED OXYGEN SENSOR (for 2WD): Removal

  1. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  2. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  3. REMOVE COWL SIDE TRIM BOARD LH  (See REMOVAL )
  4. REMOVE COWL SIDE TRIM BOARD RH  (See REMOVAL )
  5. REMOVE FRONT FLOOR SILENCER PAD LH 
  6. REMOVE FRONT FLOOR SILENCER PAD RH 
  7. REMOVE REAR NO. 2 AIR DUCT 
  8. REMOVE REAR NO. 1 AIR DUCT 
  9. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Disconnect the heated oxygen sensor connector.
      Fig 1: Locating Heated Oxygen Sensor Connector
      G06190242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the grommet.
    3. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST 09224-00010 

      Fig 2: Removing Heated Oxygen Sensor From Front Exhaust Pipe Assembly
      G06190243Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
    1. Disconnect the heated oxygen sensor connector.
      Fig 3: Locating Heated Oxygen Sensor Connector
      G06190244Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the grommet.
    3. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST 09224-00010 

      Fig 4: Removing Heated Oxygen Sensor From Front Exhaust Pipe Assembly
      G06190245Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals