Data List/Active Test
- READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Warm up the engine.
- Turn the engine switch off.
- Conned the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body electrical/(desired system)/Data List.
- According to the display on Techstream, read the "Data List"
Driver Door
DIAGNOSTIC NOTETester Display Measurement Item/Range Normal Condition Diagnostic Note Belt Anchor Switch UP Shoulder belt anchorage switch/OFF or ON ON: Up switch is pressed
OFF: Switch is not pressed- Belt Anchor Switch DOWN Shoulder belt anchorage switch/OFF or ON ON: Down switch is pressed
OFF: Switch is not pressed- Mirror Memory No. 1 Driver side position memorized with M1 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Mirror Memory No. 2 Driver side position memorized with M2 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Mirror Memory No. 3 Driver side position memorized with M3 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Passenger Door
DIAGNOSTIC NOTETester Display Measurement Item/Range Normal Condition Diagnostic Note Belt Anchor Switch UP Shoulder belt anchorage switch/OFF or ON ON: Up switch is pressed
OFF: Switch is not pressed- Belt Anchor Switch DOWN Shoulder belt anchorage switch/OFF or ON ON: Down switch is pressed
OFF: Switch is not pressed- Mirror Memory No. 1 Passenger side position memorized with M1 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Mirror Memory No. 2 Passenger side position memorized with M2 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Mirror Memory No. 3 Passenger side position memorized with M3 switch/Mem or Not Mem Mem: Memorized
Not Mem: Not memorized-
- PERFORM ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
NOTE: When a Body No. 4 (rear junction block) related vehicle switch is on, Active Test items related to vehicle switch are prohibited (double operation prohibition). Check that vehicle switches are off before performing Active Tests.- Warm up the engine.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical/(desired system)/Active Test.
- According to the display on Techstream, perform the "Active Test"
Body No. 4
DIAGNOSTIC NOTETester Display Test Part Control Range Diagnostic Note Driver Side Seat Belt Anchor Motor Seat belt anchor DOWN or UP - Passenger Side Seat Belt Anchor Motor Seat belt anchor DOWN or UP -