How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the power shoulder belt anchorage system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.
      RESULT CHART
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B:  Go to CAN COMMUNICATION SYSTEM

      A: Go to Next Step 

4. PROBLEM SYMPTOMS TABLE 
   RESULT CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  6

   A: Go to Next Step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Data List/Active Test (See DATA LIST/ACTIVE TEST  )
   2. Terminals of ECU (See TERMINALS OF ECU  )
6. ADJUST, REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END