Data List/Active Test
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical/Smart Access/Data List /
- According to the display on the Techstream, read the Data List.
Smart Access
TESTER DISPLAY REFERENCETester Display Measurement Item/Range Normal Condition Diagnostic Note Sensor Value Sensor malfunction/NG (Past) or OK NG (Past): Sensor malfunction
OK: No malfunction- Power Supply Short Short in ECU/NG (Past) or OK NG (Past): Short in ECU
OK: No malfunction- Power Supply Open Open in ECU/NG (Past) or OK NG (Past): Open in ECU
OK: No malfunction- Motor Driver Short Short in driver ECU/NG (Past) or OK NG (Past): Short in driver ECU
OK: No malfunction- Motor Driver Open Open in driver ECU/NG (Past) or OK NG (Past): Open in driver ECU
OK: No malfunction- Lock/Unlock Receive Steering lock command reception record/ YES or NO YES: Steering lock/unlock signal received
NO: Steering lock/unlock signal not received- Lock Bar Stuck Error Lock bar stuck malfunction/NG (Past) or OK NG (Past): Lock bar stuck malfunction
OK: No malfunction- Push Start Error Push button start function malfunction/NG (Past) or OK NG (Past): Malfunction in push button start
OK: No malfunction- IG2 Status IG2 voltage/ON or OFF ON: 11 to 14 V
OFF: Below 1 V- IG (Lin) LIN bus start-up status/ON or OFF ON: LIN bus started-up
OFF: LIN bus not started-up- S Code Check S code match record/NG or OK NG: S code not matched
OK: S code matched- L Code Check L code match record/NG or OK NG: L code not matched
OK: L code matched- Unlock Request Receive Steering lock unlock command reception status/NG or OK NG: Unlock request not received
OK: Unlock request received- Lock Request Receive Steering lock lock command reception status/NG or OK NG: Lock request not received
OK: Lock request received- S Code Check (Past) S code match record/NG (Past) or OK NG (Past): S code not matched
OK: S code matched- L Code Check (Past) L code match record/NG (Past) or OK NG (Past): L code not matched
OK: L code matched-