Park/Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the switch to the manual valve shaft.
2. Temporarily install the bolt.
  
  Fig 1: Locating Bolt And Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer with the nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Locating Lock Nut And Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the control shaft lever.
  
  Fig 3: Locating Transmission Control Shaft Lever And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
6. Remove the control shaft lever.
  
  Fig 4: Turning Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the neutral basic line with the groove.
8. Hold the switch in position and tighten the bolt.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
  
  Fig 5: Identifying Park/Neutral Position Switch Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Using a screwdriver, bend the tabs of the lock washer.
  HINT:
  
  Bend at least 2 washer tabs.
  
  Fig 6: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the transmission control shaft lever and spring washer with the nut.
  Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf)
11. Connect the switch connector.
Fig 7: Locating Transmission Control Shaft Lever And Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Temporarily connect the shifting rod to the connecting rod swivel with the nut.
  HINT:
  
  The nut is tightened to a torque specification during the shift lever position adjustment procedure.
  
  Fig 8: Locating Floor Shift Gear Shifting Rod
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SHIFT LEVER POSITION
1. Adjust the shift lever position (See ADJUSTMENT ).
INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY
1. Install the front exhaust pipe (See INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSTALL COWL TOP VENTILATOR LOUVER (See INSTALLATION )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Inspect the switch (See ON-VEHICLE INSPECTION ).