April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

CHECK DTC
1. Clear the DTCs (see DTC CHECK/CLEAR ).
2. Check for DTCs again.
  OK: DTC is not output.
  
  OK: END (SYSTEM OK)
  
  NG: Go to next step.

CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

Fig 1: Identifying Main Body ECU Connector Terminal And Certification ECU Connector Terminal

G04943860

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the DA main body ECU connector.
Disconnect the L15 certification ECU connector.

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE REFERENCE

Tester Connection	Condition	Specified Condition
DA-52 (LIN1) - L15-10 (LIN)	Always	Below 1 Ω
DA-52 (LIN1) or L15-10 (LIN) - Body ground	Always	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: Go to next step.

CHECK MAIN BODY ECU (OPERATION)
1. Temporarily replace the main body ECU with a new or normally functioning one.
2. Check for DTCs again.
  OK: DTC is not output.
  
  OK: GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START (ROOM OSCILLATOR DOES NOT RECOGNIZE KEY) (See ROOM OSCILLATOR DOES NOT RECOGNIZE KEY )
  
  NG: END (MAIN BODY ECU IS FAULTY)