Instrument Panel Speaker: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).
  Fig 1: Identifying Front No. 3 Speaker Assembly Connector

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY 
   1. Connect the connector
   2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
   3. Install the speaker with the 2 bolts.
      NOTE:

      • Do not touch the cone part of the speaker.
      • When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.
        Fig 2: Identifying Front No. 2 Speaker Assembly And Bolts

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 
   1. Attach the 2 clips and 7 claws to install the panel.
      Fig 3: Identifying Clips And Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL INSTRUMENT SIDE PANEL LH  (See INSTALLATION )
4. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
5. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY 
   1. Connect the speaker connector
   2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel
   3. Install the speaker with the 2 bolts
      NOTE:

      • Do not touch the cone part of the speaker.
      • When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.
        Fig 4: Identifying Speaker With Bolts

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL NO. 1 SPEAKER HOLE COVER 
   1. Attach the 4 clips to install the hole cover
7. INSTALL MULTI DISPLAY ASSEMBLY WITH BRACKET 
   1. w/o Navigation System.

      Install the multi-display (see REASSEMBLY  ).

      Fig 5: Identifying Clips And Hole Cover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. w/ Navigation System.

      Install the multi-display (see INSTALLATION ).

   3. for HDD Navigation System

      Install the display and navigation (see INSTALLATION ).

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
   NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
9. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )