Radio Receiver: Removal

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See REMOVAL )
REMOVE BATTERY SERVICE HOLE COVER LH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 3 BOX PANEL (See REMOVAL )
REMOVE REAR UPPER CONSOLE PANEL (See REMOVAL )
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
1. Remove the 2 bolts
  
  Fig 1: Locating Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull the radio receiver to detach the 4 clips on the backside of the radio receiver
3. Disconnect the connectors and remove the radio receiver
  
  Fig 2: Removing Radio Receiver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
1. Detach the 5 clips and remove the panel
  
  Fig 3: Removing Instrument Cluster Finish Panel Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 RADIO BRACKET
1. Remove the 4 bolts and bracket
  
  Fig 4: Locating Bolts And No. 2 Radio Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 RADIO BRACKET
1. Remove the 4 bolts and bracket