Stereo Component Amplifier: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS )

Fig 1: Locating Screws And No. 2 Amplifier Bracket

INSTALL NO. 2 AMPLIFIER BRACKET
1. Set the bracket's aligning protrusions labeled A into the amplifier's holes
2. Install the bracket with the 2 screws labeled B
  
  Fig 2: Locating Screws And No. 2 Amplifier Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AMPLIFIER BRACKET
1. Set the bracket's aligning protrusions labeled A into the amplifier's holes.
2. Install the bracket with the 2 screws labeled B.
  
  Fig 3: Locating Screws And No. 1 Amplifier Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
1. Install the amplifier with the 4 nuts
  HINT:
  
  Tighten the nuts in the order shown in the illustration.
  
  Fig 4: Locating Amplifier And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (See INSTALLATION )
INSTALL BATTERY SERVICE HOLE COVER (See INSTALLATION )
INSTALL NO. 1 COOLER COVER (w/ Rear Cooler) (See INSTALLATION )
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL DECK TRIM SIDE BOARD RH (See INSTALLATION )
INSTALL ROPE HOOK ASSEMBLY (See INSTALLATION )
INSTALL ROPE HOOK (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )