Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the front speed sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE: Prevent foreign matter from attaching to the sensor tip.
  
  Fig 1: Locating Front Speed Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front speed sensor with the 2 bolts and engage the 2 claws.
  Torque: Bolt A
  
  5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Bolt B
  
  19 N*m (194 kgf*cm, 14 ft.*lbf)
  NOTE:
  - Do not twist the wire harness for the front speed sensor when installing the speed sensor.
  - The bolt B tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.
  - Install the stopper firmly to the hole in the body.
    
    Fig 2: Identifying Bolts And Claws Of Speed Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the front speed sensor connector and engage the clamp.
  
  Fig 3: Locating Front Speed Sensor Connector And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FENDER LINER (See INSTALLATION )
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE )