Confirmation Driving Pattern
- Stop the engine for 30 minutes or more [A].
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure). Refer DTC CHECK/CLEAR [B].
- Turn the engine switch off.
- Turn the engine switch on (IG) and turn the Techstream on [C].
- Start the engine, and wait 2 minutes [D].
- Warm up the engine until the engine coolant temperature is 75°C (167°F) or more [E].
- Idle the engine for 1 minute [F].
- Accelerate the vehicle to 50 mph (80 km/h) and stop the vehicle [G].
- Drive the vehicle at 35 to 50 mph (56 to 80 km/h) for 5 minutes or more [H].
- Enter the following menus: Powertrain/Engine/Trouble Codes.
- Read the DTCs [I].
HINT:
- If a DTC is output, the system is malfunctioning.
- If a DTC is not output, perform the following procedure.
- Enter the following menus: Powertrain/Engine/Utility/All Readiness.
- Input the DTC: P0607, P0136, P0137, P0138, P0156, P0157 or P0158.
- Check the DTC judgment result [I].
Techstream Display Description NORMAL - DTC judgment completed
- System normal
ABNORMAL - DTC judgment completed
- System abnormal
INCOMPLETE - DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
UNKNOWN - Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU's memory limit
WARNING:When performing the confirmation driving pattern, obey all speed limits and traffic laws.
HINT:
If the judgment result shows ABNORMAL, the system has a malfunction.