Data List / Active Test
- READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / (desired system) / Data List.
- Read the Data List according to the display on the Techstream.MASTER SWITCH (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver side power window auto switch signal / ON or OFF ON: Driver side power window auto switch operated
OFF: Driver side power window auto switch not operated- P Door P/W Auto SW Front passenger side power window auto up/down switch signal / ON or OFF ON: Front passenger door power window auto switch operated
OFF: Front passenger door power window auto switch not operated- RR Door P/W Auto SW Rear RH side power window auto up / down switch signal / ON or OFF ON: Rear RH power window auto switch operated
OFF: Rear RH power window auto switch not operated- RL Door P/W Auto SW Rear LH side power window auto up / down switch signal / ON or OFF ON: Rear LH power window auto switch operated
OFF: Rear LH power window auto switch not operated- P Door P/W Up SW Front passenger side power window manual up switch signal / ON or OFF ON: Front passenger door power window manual up switch operated
OFF: Front passenger door power window manual up switch not operated- RR Door P/W Up SW Rear RH side power window manual up switch signal / ON or OFF ON: Rear RH power window manual up switch operated
OFF: Rear RH power window manual up switch not operated- RL Door P/W Up SW Rear LH side power window manual up switch signal / ON or OFF ON: Rear LH power window manual up switch operated
OFF: Rear LH power window manual up switch not operated- P Door P/W Down SW Front passenger side power window manual down switch signal / ON or OFF ON: Front passenger door power window manual down switch operated
OFF: Front passenger door power window manual down switch not operated- RR Door P/W Down SW Rear RH side power window manual down switch signal / ON or OFF ON: Rear RH power window manual down switch operated
OFF: Rear RH power window manual down switch not operated- RL Door P/W Down SW Rear LH side power window manual down switch signal / ON or OFF ON: Rear LH power window manual down switch operated
OFF: Rear LH power window manual down switch not operated- Window Lock Switch Status Window lock switch signal / ON or OFF ON: Window lock switch LOCK position
OFF: Window lock switch UNLOCK position- Door Key Linked Lock SW Driver side door lock/unlock switch lock signal (key-linked lock switch)/ON or OFF ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder turned to unlock position- Door Key Linked Unlock SW Driver side door lock/unlock switch unlock signal (key-linked unlock switch)/ON or OFF ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder turned to lock position- Door Key Linked P/W Up Door key linked power window up / ON or OFF Customization status displayed - Door key Linked P/W Down Door key linked power window down / ON or OFF Customization status displayed - P/W Down W/Transmitter Wireless transmitter linked power window down / ON or OFF Customization status displayed - Number of Trouble Codes Number of trouble codes / Min.: 0 or Max.: 255 Number of DTCs displayed - D-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE))Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver side power window auto switch signal / ON or OFF ON: Driver door power window auto switch operated
OFF: Driver door power window auto switch not operated- D Door P/W Up SW Driver side power window manual up switch signal / ON or OFF ON: Driver door power window manual up switch operated
OFF: Driver door power window manual up switch not operated- D Door P/W Down SW Driver side power window manual down switch signal / ON or OFF ON: Driver door power window manual down switch operated
OFF: Driver door power window manual down switch not operated- Glass Position (Close - 1/4) Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (1/4 - 2/4) Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (2/4 - 3/4) Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (3/4 - Open) Margin for jam protection triggering force of window glass within range of 3/4 to fully open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Number of Trouble Codes Number of trouble codes / Min.: 0 or Max.: 255 Number of DTCs displayed - P-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER SIDE))Tester Display Measurement Item/Range Normal Condition Diagnostic Note P Door P/W Auto SW Front passenger side power window auto switch signal / ON or OFF ON: Front passenger door power window auto switch operated
OFF: Front passenger door power window auto switch not operated- P Door P/W Up SW Front passenger side power window manual up switch signal / ON or OFF ON: Front passenger door power window manual up switch operated
OFF: Front passenger door power window manual up switch not operated- P Door P/W Down SW Front passenger side power window manual down switch signal / ON or OFF ON: Front passenger door power window manual down switch operated
OFF: Front passenger door power window manual down switch not operated- Glass Position (Close - 1/4) Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (1/4 - 2/4) Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (2/4 - 3/4) Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (3/4 - Open) Margin for jam protection triggering force of window glass within range of 3/4 to fully open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Number of Trouble Codes Number of trouble codes / Min.: 0 or Max.: 255 Number of DTCs displayed - RL-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH SIDE))Tester Display Measurement Item/Range Normal Condition Diagnostic Note RL Door P/W Auto SW Rear LH side power window auto switch signal / ON or OFF ON: Rear LH door power window auto switch operated
OFF: Rear LH door power window auto switch not operated- RL Door P/W Up SW Rear LH side power window manual up switch signal / ON or OFF ON: Rear LH door power window manual up switch operated
OFF: Rear LH door power window manual up switch not operated- RL Door P/W Down SW Rear LH side power window manual down switch signal / ON or OFF ON: Rear LH door power window manual down switch operated
OFF: Rear LH door power window manual down switch not operated- Glass Position (Close - 1/4) Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (1/4 - 2/4) Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (2/4 - 3/4) Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (3/4 - Open) Margin for jam protection triggering force of window glass within range of 3/4 to fully open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Number of Trouble Codes Number of trouble codes / Min.: 0 or Max.: 255 Number of DTCs displayed - RR-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH SIDE))Tester Display Measurement Item/Range Normal Condition Diagnostic Note RR Door P/W Auto SW Rear RH side power window auto switch signal / ON or OFF ON: Rear RH door power window auto switch operated
OFF: Rear RH door power window auto switch not operated- RR Door P/W Up SW Rear RH side power window manual up switch signal / ON or OFF ON: Rear RH door power window manual up switch operated
OFF: Rear RH door power window manual up switch not operated- RR Door P/W Down SW Rear RH side power window manual down switch signal / ON or OFF ON: Rear RH door power window manual down switch operated
OFF: Rear RH door power window manual down switch not operated- Glass Position (Close - 1/4) Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (1/4 - 2/4) Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (2/4 - 3/4) Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Glass Position (3/4 - Open) Margin for jam protection triggering force of window glass within range of 3/4 to fully open window glass position / OK or CAUTION OK: Normal manual up operation
CAUTION: Jam detected in the specified rangeCAUTION is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam. Number of Trouble Codes Number of trouble codes / Min.: 0 or Max.: 255 Number of DTCs displayed - MAIN BODY (MAIN BODY ECU RH (COWL SIDE JUNCTION BLOCK RH))Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver side door open
OFF: Driver side door closed- P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger side door open
OFF: Front Passenger side door closed- RR Door Courtesy SW Rear RH side door courtesy switch signal / ON or OFF ON: Rear RH side door open
OFF: Rear RH side door closed- RL Door Courtesy SW Rear LH side door courtesy switch signal / ON or OFF ON: Rear LH side door open
OFF: Rear LH side door closed-
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / (desired system) / Active Test.
- Perform the Active Test according to the display on the Techstream.WARNING:
Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.
D-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE))Tester Display Test Part Control Range Diagnostic Note Power Window Power window UP / OFF (OFF) - Power Window Power window DOWN / OFF (OFF) - P-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER SIDE))Tester Display Test Part Control Range Diagnostic Note Power Window Power window UP / OFF (OFF) - Power Window Power window DOWN / OFF (OFF) - RL-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH SIDE))Tester Display Test Part Control Range Diagnostic Note Power Window Power window UP / OFF (OFF) - Power Window Power window DOWN / OFF (OFF) - RR-DOOR MOTOR (POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH SIDE))Tester Display Test Part Control Range Diagnostic Note Power Window Power window UP / OFF (OFF) - Power Window Power window DOWN / OFF (OFF) -