Electric Power Control System: Precaution: Precaution

NOTICE FOR DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL

NOTE:

w/ Navigation System (for HDD):

After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) BATTERY TERMINAL

Condition	Waiting Time
Vehicle enrolled in safety connect system	6 minutes
Vehicle not enrolled in safety connect system	1 minute

NOTICE FOR INITIALIZATION

NOTE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System	See procedure
Advanced Parking Guidance System	Refer to INITIALIZATION
Rear Door Sunshade System
Power Trunk Lid System

PRECAUTION FOR ELECTRIC POWER CONTROL SYSTEM
1. If a load control linked system does not operate due to a problem in the electric power control system, use the Techstream to check for electric power control system DTCs, and write them down. Or, check the Data List's load control history and write down the information.
PRECAUTIONS WHEN USING TECHSTREAM
1. When using the Techstream with the engine switch on (IG):
  After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).