DTC P062F: Internal Control Module EEPROM Error: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear DTCs. Refer toDTC CHECK / CLEAR .
5. Turn the engine switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute. Refer toPRECAUTION .
8. Connect the cable to the negative (-) battery terminal. Refer toPRECAUTION .
9. Connect the Techstream to the DLC3.
10. Turn the engine switch on (IG) and turn the Techstream on.
11. Wait 30 seconds or more.
12. Enter the following menus: Powertrain / Engine / Trouble Codes.
13. Read the DTCs.
    RESULT
    
    

    Result	Proceed to
    No DTC output	A
    DTC P062F output	B

B → See step   2 

A → See step   3