Pattern Select Switch Sport Mode Circuit: Procedure

B → See step   10 

A: Go to next step 

B → GO TO DTC CHART 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Body Electrical / Combination Meter / Active Test / Indicat. Lamp ECT PWR.
4. Perform the "Indicat. Lamp ECT PWR" Active Test.

   OK

   The SPORT mode indicator lamp comes on or blinks.

5. Turn the power switch off.

NG → See step   11 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Data List / Pattern Switch (PWR/M).
4. Read the value displayed on the Techstream.

   Tester Display	Measurement Item/Range	Normal Condition
   Pattern Switch (PWR/M)	SPORT mode transition availability/ ON or OFF	In SPORT mode: ON

   Result

   Result	Proceed to
   The Techstream display changes according to the mode switch (SPORT mode) operation.	A
   The Techstream display does not changes according to the mode switch (SPORT mode) operation.	B

B → See step   5 

A → See step   9 

1. Remove the combination switch assembly.
2. Measure the resistance according to the value(s) in the table below.
   Fig 1: Identifying Combination Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H72-6 (PWR) - H72-14 (E)	Mode switch being turned and held at SPORT position	Below 1 Ω
   	Mode switch not turned	10 kΩ or higher
   H72-4 (NORM) - H72-14 (E)	Mode switch being pushed and held	Below 1 Ω
   	Mode switch not pushed	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Combination Switch Assembly)

3. Install the combination switch assembly.

NG → See step   8 

OK: Go to next step 

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect connector A60 from the ECM.
2. Disconnect connector H72 from the combination switch assembly.
3. Measure the resistance according to the value(s) in the table below.
   Fig 2: Identifying A60 And H72 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A60-46 (PWMS) - H72-6 (PWR)	Always	Below 1 Ω
   A60-46 (PWMS) or H72-6 (PWR) - Body ground	Always	10 kΩ or higher
   A60-30 (NE01) - H72-4 (NORM)	Always	Below 1 Ω
   A60-30 (NE01) or H72-4 (NORM) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to ECM)
   *b	Front view of wire harness connector (to Combination Switch Assembly)

4. Connect the combination switch assembly connector.
5. Connect the ECM connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   12