On-Vehicle Inspection
- INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Put the engine in inspection mode (maintenance mode). Refer to INSPECTION MODE PROCEDURE .
- Start the engine.
- Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1).
- Check the engine speed while operating the camshaft timing oil control valve assembly using the Techstream.
HINT:
- If the result is not acceptable, cool the engine (engine coolant temperature is 30°C (86°F) or less) and perform the Active Test again.
- Test not possible with park (P) selected during charge control. Move shift lever to N to perform test.
Standard
Techstream Operation Specified Condition 0% Normal engine speed 100% Engine idles roughly or stalls