Ignition Coil And Spark Plug: Installation: Installation

INSTALL SPARK PLUG
1. Using a 16 mm plug wrench, install the 8 spark plugs.
  
  Fig 1: Installing Spark Plugs
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
INSTALL IGNITION COIL ASSEMBLY
1. Install the 8 ignition coils with the 8 bolts.
  
  Fig 2: Identifying Ignition Coils Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Do not damage the ignition coils when installing them.
  
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
2. Connect the 8 ignition coil connectors.
INSTALL WIRE HARNESS CLAMP BRACKET
1. Install the wire harness clamp bracket with the bolt.
  
  Fig 3: Identifying Wire Harness Clamp Bracket & Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
2. Install the wire harness clamp to the clamp bracket.
3. Install the No. 7 engine room relay block with the 2 bolts and nut.
  
  Fig 4: Identifying No. 7 Engine Room Relay Block, Bolts, & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
INSTALL BATTERY TRAY
1. Install the battery tray with the 3 bolts.
  
  Fig 5: Identifying Battery Tray And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSTALL POWER STEERING ECU ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL NO. 1 BATTERY TRAY SUPPORT
INSTALL BATTERY
1. Install the battery.
2. Install the battery insulator.
3. Install the battery clamp with a nut.
  Torque: 2.9 N*m (30 kgf*cm, 26 in.*lbf)
4. Connect the cable to the positive (+) battery terminal.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
5. Connect the 2clamps.
  
  Fig 6: Identifying Battery Clamp And Battery Insulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP SUB-ASSEMBLY See step 2
INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION - Step 93
INSTALL ENGINE ROOM SIDE COVER RH . Refer to INSTALLATION - Step 92
INSTALL COOL AIR INTAKE DUCT SEAL . Refer to INSTALLATION - Step 94
INSTALL V-BANK COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 95
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
1. Connect the cable to the negative (-) battery terminal.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  NOTE:
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .