LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2011 >> IS F >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Control System (Service Information)) >> Crankshaft Position Sensor >> Installation (To 12/2010) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation (To 12/2010): Installation

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
  2. INSTALL COOLER COMPRESSOR ASSEMBLY  . Refer to INSTALLATION - Step 32
  3. INSTALL GENERATOR ASSEMBLY  . Refer to INSTALLATION - Step 1
  4. INSTALL V-RIBBED BELT  . Refer to INSTALLATION - Step 1
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

scientia non olet · About LEMON Manuals