Knock Sensor: Removal: Removal

HINT: 

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

1. REMOVE INTAKE MANIFOLD 
   1. Remove the intake manifold. Refer to REMOVAL .
2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 5
3. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 6
4. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY LH  . Refer to REMOVAL - Step 7
5. REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY  . Refer to REMOVAL - Step 8
6. REMOVE SEPARATOR CASE 
   1. Disconnect the fuel pressure sensor connector.
      Fig 1: Identifying Fuel Pressure Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the 4 bolts and separator case.
      Fig 2: Locating Separator Case And Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. REMOVE KNOCK SENSOR 
   Fig 3: Locating Knock Sensor Connectors And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Disconnect the 4 sensor connectors.
   2. Remove the 4 bolts and 4 sensors.