DTC P060B: Internal Control Module A/D Processing Performance: Procedure
- CHECK DTC
- Clear DTC. Refer to DTC CHECK / CLEAR .
- Turn the power switch off.
- Disconnect the cable from the negative battery terminal and wait for 1 minute.
- Connect the cable to the negative battery terminal.
- Turn the power switch on (IG).
- Check DTC.RESULT
Display (DTC Output) Proceed to No output A P060B B P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D C
B → See step 3
C → See step 4
A → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
- REPLACE ECM. Refer to REMOVAL
- GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D). Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input