| Multi-terrain ABS, BA and/or EBD does not Operate |
Check for DTCs again and make sure that no DTC is output. |
Refer to DTC CHECK / CLEAR |
| IG power source circuit |
Refer to DTC C1241/41: Low Battery Positive Voltage |
| Front speed sensor circuit |
Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH |
| Rear speed sensor circuit |
Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH |
| Yaw rate and G sensor circuit |
Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction |
| Check the hydraulic brake booster with Techstream. If abnormal, check the hydraulic circuit for leakage. |
Refer to ON-VEHICLE INSPECTION |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. |
Refer to DISASSEMBLY - Step 9 |
| Multi-terrain ABS, BA and/or EBD does not Operate Efficiently |
Check for DTCs again and make sure that no DTC is output. |
Refer to DTC CHECK / CLEAR |
| Front speed sensor circuit |
Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH |
| Rear speed sensor circuit |
Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH |
| Stop light switch circuit |
Refer to DTC C1249/49: Open in Stop Light Switch Circuit |
| Yaw rate and G sensor circuit |
Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction |
| Check the hydraulic brake booster with Techstream. If abnormal, check the hydraulic circuit for leakage. |
Refer to ON-VEHICLE INSPECTION |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. |
Refer to DISASSEMBLY - Step 9 |
| VSC, A-TRAC, CRAWL, and/or Hill-start Assist Control does not Operate |
Check for DTCs again and make sure that no DTC is output. |
Refer to DTC CHECK / CLEAR |
| IG power source circuit |
Refer to DTC C1241/41: Low Battery Positive Voltage |
| Check the hydraulic circuit for leakage |
Refer to SYSTEM DIAGRAM |
| Front speed sensor circuit |
Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH |
| Rear speed sensor circuit |
Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH |
| Yaw rate and G sensor circuit |
Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction |
| Steering angle sensor circuit |
Refer to DTC C1231/31: Steering Angle Sensor Circuit Malfunction |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. |
Refer to DISASSEMBLY - Step 9 |
| Sensor and Switch Signal Check cannot be Done |
TS and CG terminal circuit |
Refer to TS and CG Terminal Circuit |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| DTC Check cannot be Done |
Check for DTCs again and make sure that no DTC is output. |
Refer to DTC CHECK / CLEAR |
| TC and CG terminal circuit |
Refer to TC and CG Terminal Circuit |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. |
Refer to DISASSEMBLY - Step 9 |
| ABS Warning Light Abnormal (Remains On) |
ABS warning light circuit |
Refer to ABS Warning Light Remains ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| ABS Warning Light Abnormal (Does not Come On) |
ABS warning light circuit |
Refer to ABS Warning Light does not Come ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| Brake Warning Light Abnormal (Remains On) |
Brake warning light circuit |
Refer to Brake Warning Light Remains ON |
| Brake fluid level warning switch circuit |
Refer to DTC C1202/58: Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| Brake Warning Light Abnormal (Does not Come On) |
Brake warning light circuit |
Refer to Brake Warning Light does not Come ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| VSC OFF Indicator Light Abnormal (Remains On) |
Transfer indicator (L4) switch circuit |
Refer to DTC C1268/68: Transfer "L4" Position Switch Circuit |
| VSC OFF indicator light circuit |
Refer to VSC OFF Indicator Light Remains ON |
| Center differential lock circuit |
Refer to DTC C1340/47: Center Differential Lock Circuit |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| VSC OFF Indicator Light Abnormal (Does not Come On) |
Transfer indicator (L4) switch circuit |
Refer to DTC C1268/68: Transfer "L4" Position Switch Circuit |
| VSC OFF indicator light circuit |
Refer to VSC OFF Indicator Light does not Come ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| CRAWL Indicator Light Abnormal (Remains On) |
CRAWL indicator light circuit |
Refer to Crawl Indicator Light Remains ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| CRAWL Indicator Light Abnormal (Does not Come On) |
CRAWL indicator light circuit |
Refer to Crawl Indicator Light does not Come ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| Slip Indicator Light Abnormal (Remains On) |
Slip indicator light circuit |
Refer to Slip Indicator Light Remains ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| Slip Indicator Light Abnormal (Does not Come On) |
Slip indicator light circuit |
Refer to Slip Indicator Light does not Come ON |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |
| Skid Control Buzzer Abnormal |
Skid control buzzer circuit |
Refer to Skid Control Buzzer Circuit |
| Master cylinder solenoid |
Refer to DISASSEMBLY - Step 9 |