Problem Symptoms Table
If there are no DTCs output but the problem still occurs, check the suspected areas for each problem symptom in the order given in the table below and proceed to the relevant "See".
NOTE:
When replacing the master cylinder solenoid, sensor, etc., turn the engine switch off.
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
VEHICLE STABILITY CONTROL SYSTEM
| Symptom | Suspected Area | See |
|---|---|---|
| Multi-terrain ABS, BA and/or EBD does not Operate | Check for DTCs again and make sure that no DTC is output. | Refer to DTC CHECK / CLEAR |
| IG power source circuit | Refer to DTC C1241/41: Low Battery Positive Voltage | |
| Front speed sensor circuit | Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH | |
| Rear speed sensor circuit | Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH | |
| Yaw rate and G sensor circuit | Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction | |
| Check the hydraulic brake booster with Techstream. If abnormal, check the hydraulic circuit for leakage. | Refer to ON-VEHICLE INSPECTION | |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. | Refer to DISASSEMBLY | |
| Multi-terrain ABS, BA and/or EBD does not Operate Efficiently | Check for DTCs again and make sure that no DTC is output. | Refer to DTC CHECK / CLEAR |
| Front speed sensor circuit | Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH | |
| Rear speed sensor circuit | Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH | |
| Stop light switch circuit | Refer to DTC C1249/49: Open in Stop Light Switch Circuit | |
| Yaw rate and G sensor circuit | Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction | |
| Check the hydraulic brake booster with Techstream. If abnormal, check the hydraulic circuit for leakage. | Refer to ON-VEHICLE INSPECTION | |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. | Refer to DISASSEMBLY | |
| VSC, A-TRAC, CRAWL, and/or Hill-start Assist Control does not Operate | Check for DTCs again and make sure that no DTC is output. | Refer to DTC CHECK / CLEAR |
| IG power source circuit | Refer to DTC C1241/41: Low Battery Positive Voltage | |
| Check the hydraulic circuit for leakage | Refer to SYSTEM DIAGRAM | |
| Front speed sensor circuit | Refer to DTC C0200/31: Front Speed Sensor RH Circuit; DTC C0205/32: Front Speed Sensor LH Circuit; DTC C1235/35: Foreign Object is Attached on Tip of Front Speed Sensor RH; DTC C1236/36: Foreign Object is Attached on Tip of Front Speed Sensor LH | |
| Rear speed sensor circuit | Refer to DTC C0210/33: Rear Speed Sensor RH Circuit; DTC C0215/34: Rear Speed Sensor LH Circuit; DTC C1238/38: Foreign Object is Attached on Tip of Rear Speed Sensor RH; DTC C1239/39: Foreign Object is Attached on Tip of Rear Speed Sensor LH | |
| Yaw rate and G sensor circuit | Refer to DTC C1232/32: Stuck in Deceleration Sensor; DTC C1234/34: Yaw Rate Sensor Malfunction; DTC C1243/43: Acceleration Sensor Stuck Malfunction; DTC C1244/44: Open or Short in Deceleration Sensor Circuit; DTC C1245/45: Acceleration Sensor Output Malfunction; DTC C1381/97: Acceleration Sensor Power Supply Voltage Malfunction | |
| Steering angle sensor circuit | Refer to DTC C1231/31: Steering Angle Sensor Circuit Malfunction | |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. | Refer to DISASSEMBLY | |
| Sensor and Switch Signal Check cannot be Done | TS and CG terminal circuit | Refer to TS and CG Terminal Circuit |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| DTC Check cannot be Done | Check for DTCs again and make sure that no DTC is output. | Refer to DTC CHECK / CLEAR |
| TC and CG terminal circuit | Refer to TC and CG Terminal Circuit | |
| If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid. | Refer to DISASSEMBLY | |
| ABS Warning Light Abnormal (Remains On) | ABS warning light circuit | Refer to ABS Warning Light Remains ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| ABS Warning Light Abnormal (Does not Come On) | ABS warning light circuit | Refer to ABS Warning Light does not Come ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| BRAKE Warning Light Abnormal (Remains On) | BRAKE warning light circuit | Refer to Brake Warning Light Remains ON |
| Brake fluid level warning switch circuit | Refer to DTC C1202/58: Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit | |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| BRAKE Warning Light Abnormal (Does not Come On) | BRAKE warning light circuit | Refer to Brake Warning Light does not Come ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| VSC OFF Indicator Light Abnormal (Remains On) | Transfer indicator (L4) switch circuit | Refer to DTC C1268/68: Transfer "L4" Position Switch Circuit |
| VSC OFF indicator light circuit | Refer to VSC OFF Indicator Light Remains ON | |
| Center differential lock circuit | Refer to DTC C1340/47: Center Differential Lock Circuit | |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| VSC OFF Indicator Light Abnormal (Does not Come On) | Transfer indicator (L4) switch circuit | Refer to DTC C1268/68: Transfer "L4" Position Switch Circuit |
| VSC OFF indicator light circuit | Refer to VSC OFF Indicator Light does not Come ON | |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| TRAC OFF Indicator Light Abnormal (Remains On) | TRAC OFF indicator light circuit | Refer to TRAC OFF Indicator Light Remains ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| TRAC OFF Indicator Light Abnormal (Does not Come On) | TRAC OFF indicator light circuit | Refer to TRAC OFF Indicator Light does not Come ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| CRAWL Indicator Light Abnormal (Remains On) | CRAWL indicator light circuit | Refer to Crawl Indicator Light Remains ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| CRAWL Indicator Light Abnormal (Does not Come On) | CRAWL indicator light circuit | Refer to Crawl Indicator Light does not Come ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| Slip Indicator Light Abnormal (Remains On) | Slip indicator light circuit | Refer to Slip Indicator Light Remains ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| Slip Indicator Light Abnormal (Does not Come On) | Slip indicator light circuit | Refer to Slip Indicator Light does not Come ON |
| Master cylinder solenoid | Refer to DISASSEMBLY | |
| Skid Control Buzzer Abnormal | Skid control buzzer circuit | Refer to Skid Control Buzzer Circuit |
| Master cylinder solenoid | Refer to DISASSEMBLY |