Installation (08/2010 - 08/2011): Installation

INSTALL POWER STEERING OIL PRESSURE SWITCH
1. Install a new O-ring to the oil pressure switch.
2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.
  NOTE:
  - When reusing the oil pressure switch, inspect the O-ring.
  - If the O-ring has scratches or cuts, replace the new O-ring.
3. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 1: Locating Power Steering Oil Pressure Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the oil pressure switch connector.
INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
1. Install the sensor with the bolt and nut.
  for bolt
  
  Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
  
  for nut
  
  Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)
  
  Fig 2: Locating Front Height Control Sensor Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
INSTALL FAN & GENERATOR V BELT . Refer to INSTALLATION - Step 1
INSTALL AIR CLEANER ASSEMBLY . Refer to INSTALLATION - Step 37
INSTALL AIR CLEANER HOSE ASSEMBLY . Refer to INSTALLATION - Step 10
ADD POWER STEERING FLUID
BLEED POWER STEERING FLUID . Refer to ON-VEHICLE INSPECTION - Step 2
INSPECT FOR POWER STEERING FLUID LEAK
INSTALL FRONT FENDER APRON SEAL FRONT RH . Refer to INSTALLATION - Step 16
INSTALL FRONT WHEEL . Refer to INSTALLATION - Step 2
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 19
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH . Refer to INSTALLATION - Step 17
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH . Refer to INSTALLATION - Step 18
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
PERFORM VEHICLE HEIGHT OFFSET CALIBRATION . Refer to INSTALLATION - Step 4
ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY . Refer to ADJUSTMENT - Step 1
PERFORM ZERO POINT CALIBRATION OF G SENSOR . Refer to INSTALLATION - Step 7
ADJUST HEADLIGHT ASSEMBLY . Refer to INSTALLATION - Step 8
INSTALL V-BANK COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 72
INSTALL UPPER RADIATOR SUPPORT SEAL . Refer to INSTALLATION - Step 2
INSTALL ENGINE ROOM SIDE COVER RH . Refer to INSTALLATION - Step 4
INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION - Step 3