Jam Protection Function does not Operate: Procedure

PERFORM INITIALIZATION (APPLICABLE LOCATION)
1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
1. Check if the power window auto up and down functions operate normally. Refer to OPERATION CHECK .
  OK
  
  Auto up and down functions are normal.
NG → See step 4

OK: Go to next step

CHECK JAM PROTECTION FUNCTION OPERATING RANGE

Check if the jam protection function operates normally for the applicable power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

Jam protection function operates normally.

Result

Result	Proceed to
OK	A
NG (Driver door power window)	B
NG (Front passenger side power window)	B
NG (Rear LH side power window)	C
NG (Rear RH side power window)	C

B → See step 5

C → See step 6

A → END (PROBLEM DUE TO INITIALIZATION FAILURE)

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side or Front Passenger Side). Refer to REMOVAL
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side or Rear RH Side). Refer to REMOVAL