LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2012 >> CT 200h Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostic Codes (P0300 - P106A)) >> SFI System >> DTC P060E: Internal Control Module Throttle Position Performance >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P060E: Internal Control Module Throttle Position Performance: Procedure

  1. READ OUTPUT DTC (DTC P060E) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
    5. Turn the power switch off.
    6. Turn the Techstream off.
    7. Disconnect the Techstream.
    8. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
    9. Connect the cable to the negative (-) auxiliary battery terminal.
    10. Connect the Techstream to the DLC3.
    11. Turn the power switch on (IG).
    12. Turn the Techstream on.
    13. Wait 16 seconds or more.
    14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    15. Read the DTCs.
      RESULT

      Result Proceed to
      DTC is not output A
      DTC P060E is output B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals