Driving Support Switch Control Ecu: Removal: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:- w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- w/ Navigation System for HDD:
- REMOVE DOOR SCUFF PLATE ASSEMBLY RH . Refer to REMOVAL - Step 6
- REMOVE COWL SIDE TRIM BOARD RH . Refer to REMOVAL - Step 8
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH . Refer to REMOVAL - Step 6
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to REMOVAL - Step 2
- REMOVE INSTRUMENT LOWER COVER LH . Refer to REMOVAL - Step 28
- REMOVE NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY . Refer to REMOVAL - Step 7
- REMOVE INSTRUMENT SIDE PANEL RH . Refer to REMOVAL - Step 25
- REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to REMOVAL - Step 26
- REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY . Refer to REMOVAL - Step 27
- REMOVE INSTRUMENT PANEL BOX DOOR COVER . Refer to REMOVAL - Step 30
- REMOVE INSTRUMENT PANEL BOX ASSEMBLY . Refer to REMOVAL - Step 31
- REMOVE DRIVING SUPPORT SWITCH CONTROL ECU
- Disconnect the connector.
- Remove the bolt and driving support switch control ECU.