DTC P060A: Internal Control Module Monitoring Processor Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTC. Refer to DTC CHECK/CLEAR .
5. Turn the power switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the auxiliary battery negative (-) terminal and wait for 1 minute.
8. Connect the cable to the auxiliary battery negative (-) terminal.
9. Connect the Techstream to the DLC3.
10. Turn the power switch on (IG).
11. Wait 16 seconds or more.
12. Turn the Techstream on.
13. Enter the following menus: Powertrain/Engine and ECT/Trouble Codes.
14. Read the DTCs.

    Result

    Result	Proceed to
    DTC is not output	A
    DTC P060A is output	B

B → See step   3 

A → See step   2