LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2012 >> IS 250C Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (4GR-FSE) (Service Information) >> Crankshaft Position Sensor >> Inspection >> Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Inspection: Inspection

  1. INSPECT CRANKSHAFT POSITION SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Crankshaft Position Sensor Connector Terminals
      GTY141851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Temperature Specified Condition
      Cold 1630 to 2740 Ω
      Hot 2065 to 3225 Ω
      NOTE:

      In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

      If the resistance is not as specified, replace the sensor.

scientia non olet · About LEMON Manuals