Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated): Procedure

1. Initialize the power window control system (applicable location). Refer to INITIALIZATION .

NEXT: Go to next step 

1. Check that the auto up* and down function using the power window regulator master switch assembly and power window regulator switch assembly operates the power windows. Refer to OPERATION CHECK .

   OK

   Auto up* and down function operates normally.

   *: w/ Front Passenger Door Auto Up Function

NG → See step   3 

OK → END (INITIALIZATION WAS DEFECTIVE) 

1. Remove the window regulator.
2. Install the window glass onto the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.

   OK

   Door window glass slides smoothly.

   HINT: 

   Ensure the following:

   • The window glass fits with the glass run without improper contact.
   • Neither deformation nor foreign objects are in the glass run.
   WARNING:

   Perform initialization again.

   RESULT
   
   

   Result	Proceed to
   NG	A
   OK (Driver door window)	B
   OK (Front passenger door window)*	C

   *: w/ Front Passenger Door Auto Up Function

B → See step   4 

C → See step   5 

A → FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FITTING OR REPLACE PARTS)