Service Data
| Starter assembly | Specified current | 90 A or less at 11.5 V | |
| Starter armature assembly | Standard resistance | Segment - Segment | Below 1 Ω |
| Commutator - Armature coil core | 10 kΩ or higher | ||
| Starter armature assembly | Standard length | 3.1 to 3.8 mm (0.122 to 0.149 in.) | |
| Maximum length | 3.8 mm (0.149 in.) | ||
| Brush length | Standard length | 4.0 to 9.0 mm (0.158 to 0.354 in.) | |
| Minimum length | 4.0 mm (0.158 in.) | ||
| Starter commutator end frame assembly | Standard resistance | Positive (+) brush - Negative (-) brush | 10 kΩ or higher |
| Repair service starter kit | Specified condition | Terminal 50 - Terminal C | Below 1 Ω |
| Terminal 50 - Switch body | Below 2 Ω | ||
| Snap ring | Maximum length | 5.0 mm (0.197 in.) | |
| Starter relay | Specified condition | 3 - 5 (Battery voltage is applied between terminals 1 and 2) |
Below 1 Ω |
| 3 - 5 (Battery voltage is not applied between terminals 1 and 2) |
10 kΩ or higher | ||
| Starter cut relay | Specified condition | 3 - 5 (Battery voltage is applied between terminals 1 and 2) |
Below 1 Ω |
| 3 - 5 (Battery voltage is not applied between terminals 1 and 2) |
10 kΩ or higher | ||
| Engine switch | 7 (SS1) - 5 (GND) / 2 (SS2) - 5 (GND) Specified resistance Not pushed: 10kΩ or higher Pushed: 15 Ω |
||
| Standard condition: Illuminates Measurement condition Battery positive 11 (SWIL) - Battery negative 4 (COM) or 5 (GND) Battery positive 12 (INDS) - Battery negative 4 (COM) or 5 (GND) Battery positive 13 (INDW) - Battery negative 4 (COM) or 5 (GND) |
|||