Common Specs & Procedures
IS250C COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | N/A | ||
| Rear | 290 N.m (2, 957 kgf.cm 214 ft.lbf) | ||
| Battery | ON-VEHICLE INSPECTION | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING | ||
| Front Brakes | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Rear Brakes | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Belt Routing | INSTALLATION | ||
| Belt Tensioning | ON-VEHICLE INSPECTION | ||
| Engine Cooling | |||
| General Service Specifications | SERVICE DATA | ||
| Radiator Cap Pressure | Standard value (for brand-new cap) 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2 , 13.5 to 17.8 psi) Minimum standard value (after using cap) 78.5 kPa (0.8 kgf/cm2 , 11.4 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical (4GR-FSE) | |||
| Compression | SERVICE DATA | ||
| Oil Pressure | At Idle: 80 kPa (0.8 kgf.cm2 , 11.6 psi) or more At 6, 000 RPM: 380 kPa (3.9 kgf.cm2 , 55.5 psi) |
||
| Overhaul | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 73 N.m (741 kgf.cm, 54 ft.lbf) | ||
| Fuel System | |||
| Pressure Specification | 196 to 588 kPa (2 to 6 kgf/cm2 , 28 to 85 psi) | ||
| Fuel Pressure Test Procedure | ON-VEHICLE INSPECTION | ||
| Fuel Filter Location | FUEL PUMP | ||
| Fuel Filter R & I | FUEL PUMP | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| Type | DENSO FK20HBR11 | ||
| Gap | Standard electrode gap 1.0 - 1.1 mm (0.039 - 0.043 in.) Maximum electrode gap 1.4 mm (0.051 in.) |
||
| Torque | 18 N.m (184 kgf.cm, 13 ft.lbf) | ||
| Starting (4GR-FSE) | |||
| Starter | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 103 N.m (1, 050 kgf.cm 76 ft.lbf) | ||