Crankshaft Position Sensor: Installation: Installation
WARNING: This page is about a different car, the 2012 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the crankshaft position sensor connector.
- INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) . Refer to INSTALLATION - Step 1
- INSTALL COMPRESSOR AND MAGNETIC CLUTCH (for 4WD) . Refer to INSTALLATION - Step 6
- INSTALL DISCHARGE HOSE SUB-ASSEMBLY . Refer to INSTALLATION - Step 2
- INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE . Refer to INSTALLATION - Step 3
- INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (for 4WD) . Refer to INSTALLATION - Step 4
- INSTALL OIL FILTER BRACKET (for 4WD) . Refer to REASSEMBLY - Step 68
- INSTALL V-RIBBED BELT . Refer to INSTALLATION - Step 1
- INSTALL REAR ENGINE UNDER COVER LH (for 2WD) . Refer to INSTALLATION - Step 111
- INSTALL ENGINE UNDER COVER
- INSTALL NO. 1 INLET AIR CLEANER . Refer to INSTALLATION - Step 87
- INSTALL V-BANK COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 115
- INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION - Step 116
- INSTALL ENGINE ROOM SIDE COVER RH . Refer to INSTALLATION - Step 117
- CHARGE REFRIGERANT . Refer to REPLACEMENT - Step 2
- WARM UP ENGINE . Refer to REPLACEMENT - Step 3
- CHECK FOR LEAKAGE OF REFRIGERANT . Refer to REPLACEMENT - Step 4