Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master switch / Data List.
5. Read the Data List according to the display on the Techstream.
   MASTER SWITCH (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto up/down switch signal / ON or OFF	ON: Driver side power window auto switch operated OFF: Driver side power window auto switch not operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   4 

OK: Go to next step 

1. Replace the power window regulator motor assembly (for driver side). Refer to REMOVAL .

NEXT: Go to next step 

1. Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated. Refer to OPERATION CHECK .

   OK

   Driver side auto up/down function is normal.

NG → See step   4 

OK → END (POWER WINDOW REGULATOR MOTOR ASSEMBLY IS DEFECTIVE)