DTC P0617: Starter Relay Circuit High: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine / Data List / Starter Signal.
4. Check the value displayed on the Techstream when the vehicle is driven at 20 km/h (12.4 mph) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   OK

   Condition	Starter Signal	Proceed to
   Driving at 20 km/h (12.4 mph) or more	Close (Starter signal off)	A
   	Open (Starter signal on)	B

B → See step   2 

A → See step   5 

1. Inspect the park/neutral position switch. Refer to INSPECTION .

NG → See step   6 

OK: Go to next step 

1. Repair or replace harness or connector (park/neutral position switch assembly - ST relay - ECM).

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain / Engine / Trouble Codes.
7. Read the DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P0617 is output	B

B → See step   7 

A → END