LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2012 >> LFA >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> EVAP >> EVAP Drive Cycle 9 >> Purge Flow Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Purge Flow Monitor

  1. Connect the Techstream to the DLC3.
  2. Put the engine in inspection mode.
  3. Confirm the following conditions are satisfied:
    • The engine coolant temperature is more than 4.4°C (40°F).
    • The intake air temperature is more than 4.4°C (40°F).
  4. Perform the following drive pattern:
    1. Remove and reinstall the fuel cap to release the fuel tank pressure.
    2. Warm the engine until the engine coolant temperature reaches 75°C (167°F) or more.
    3. Run the engine at 2500 rpm once.
  5. Check the monitor status with the Techstream.
scientia non olet · About LEMON Manuals