How To Proceed With Troubleshooting

HINT: 

• Use these procedures to troubleshoot the power door lock control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. CHECK FOR DTC (ELECTRIC POWER CONTROL SYSTEM)* 
   1. Using the Techstream, check if the electric power control system is functioning normally.
      RESULT
      
      

      Result	Proceed to
      DTC B22B3 is not output	A
      DTC B22B3 is output	B

      B → Go to ELECTRIC POWER CONTROL SYSTEM. Refer to  PRECAUTION 

      A: Go to next step 

4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN Communication System is functioning normally.
      RESULT
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → Go to CAN COMMUNICATION SYSTEM. Refer to  PRECAUTION 

      A: Go to next step 

5. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the LIN Communication System is functioning normally.
      RESULT
      
      

      Result	Proceed to
      LIN DTC is not output	A
      LIN DTC is output	B

      B → Go to LIN COMMUNICATION SYSTEM. Refer to  PRECAUTION 

      A: Go to next step 

6. CHECK FOR DTC* 
   1. Check for DTCs. Refer to DTC CHECK/CLEAR .
   2. Clear the DTCs. Refer to DTC CHECK/CLEAR .
   3. Recheck for DTCs. Refer to DTC CHECK/CLEAR .
      RESULT
      
      

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

      B → Go to DIAGNOSTIC TROUBLE CODE TABLE 

      A: Go to next step 

7. PROBLEM SYMPTOMS TABLE 
   RESULT
   
   

   Result	Proceed to
   Fault is not listed on problem symptoms table	A
   Fault is listed on problem symptoms table	B

   B → Go to step   9 

   A: Go to next step 

8. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Refer to OPERATION CHECK 
   2. Refer to DATA LIST/ACTIVE TEST 
   3. Refer to TERMINALS OF ECU 

      NEXT: Go to next step 

9. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

10. CONFIRMATION TEST 

    NEXT → END