Height Control Compressor: Installation: Installation

1. Install the 3 bushings and bracket to the height control compressor with the 3 bolts.
   Fig 1: Identifying Bolts, Bushings & Bracket

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf) 

2. Push the connector into the housing until a clicking sound is heard.
3. Attach the 3 clamps.
4. Install the height control sensor with the bolt and 2 nuts.
   Fig 2: Identifying Height Control Compressor Bracket Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 19.1 N*m (195 kgf*cm, 14 ft.*lbf) 

5. Connect the height control tube. Refer to PRECAUTION .
6. Connect the height control filter to the bumper reinforcement.
7. Connect the 2 connectors and attach the 2 clamps.
   Fig 3: Identifying Connectors And Clamps

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Perform initialization. Refer to INITIALIZATION .
   NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .

1. Inspect for air leak. Refer to OPERATION CHECK .

1. Install the 2 bolts.

Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)