LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2012 >> LS 460L RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Steering Angle Sensor >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Installation: Installation

NOTE:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

  1. INSTALL STEERING ANGLE SENSOR 
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 2
  3. INSTALL STEERING COLUMN COVER (w/o Driver Monitor Camera)  . Refer to INSTALLATION - Step 16
  4. INSTALL STEERING COLUMN COVER (w/ Driver Monitor Camera)  . Refer to INSTALLATION - Step 17
  5. ADJUST SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 5
  6. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 1
  7. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  8. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  9. INSTALL SWITCH AND VOLUME CASE 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  . Refer to INSTALLATION - Step 25
  11. INSTALL COWL TOP VENTILATOR LOUVER RH  . Refer to INSTALLATION - Step 17
  12. INSPECT STEERING PAD  . Refer to INSTALLATION - Step 5
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .
  14. PERFORM INITIALIZATION 
    1. Perform initialization. Refer to INITIALIZATION .
      NOTE:

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

scientia non olet · About LEMON Manuals