Installation

2GR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

(a) Install a new gasket onto the engine coolant temperature sensor.

(b) Install the engine coolant temperature sensor and gasket.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(c) Connect the engine coolant temperature sensor connector.

2. INSTALL AIR CLEANER ASSEMBLY Installation

3. INSTALL NO. 1 AIR CLEANER INLET Installation

4. INSTALL NO. 2 AIR CLEANER INLET Installation

5. INSTALL BATTERY Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. ADD ENGINE COOLANT Service and Repair

8. INSPECT FOR COOLANT LEAK Testing and Inspection

9. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

10. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

11. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Install the windshield wiper motor and link assembly Installation.

12. INSTALL NO. 1 ENGINE UNDER COVER